Thin-Set Mortar is a blend of Portland Cement, sand and adhesive chemicals. PMP Thin-Set Mortar is designed for bonding glazed and unglazed ceramic tile, glazed wall tile, quarry tile, stone, marble, thin brick, and cement tiles to properly prepared substrates.

 Thin Set Data Sheet 236 Kb

Acrylic Fortifier is a high solids, acrylic latex polymer formulated for use with Portland cement mortars. Acrylic Fortifier is Non-remulsifiable and modified to provide superior bonding properties. Modified mortars have better flexural strength, durability, adhesion, less water absorption, color retention, and curing properties. Acrylic Fortifier is water based for easy clean-up and use.

 Acrylic Fortifier Data Sheet 10.90 Kb

Glass Block Mortar is a dry, factory blended mortar specifically designed for the installation of glass block. The product is a thoroughly blended mix of white cement, lime, water repellant agents and silica sand. Standard color is bright white.

 Glass Block Data Sheet 236 Kb

 Glass Block MSDS 68 Kb

Medium Bed Setting Mortar is a dry-set mortar for installing higher lugged tiles, pavers, stone, marble, and requiring a setting bed of 3/8" to 3/4". It may be used for interior or exterior applications. MB Setting Mortar may be mixed with only water or for superior performance mix with Acrylic Fortifier. Medium Bed Setting Mortar is available in grey or white.

 Medium Bed Setting Data Sheet 236 Kb

Wall Mud is a dry, factory blended plaster mix specifically designed for the tile contractor. The control of mix ratio and quality of sand make it a superior product than jobsite mixes.The product is a blend of cement, lime and sand. Wall Mud may be pumped. It may be used for interior or exterior walls. Mix with water only or for optimum performance 1/2 of the mixing water may be replaced with Acrylic Fortifier.

 Wall Mud Data Sheet 236 Kb

 Wall Mud MSDS 68 Kb

Dry Pack is a dry, factory blended mortar specifically designed for use by tile and masonry contractors. The product is a thoroughly blended mix of washed plaster sand and Type II cement. Pre-blending allows the cement to thoroughly coat the sand particles thus producing a stronger than jobsite mixing. The mortar is mixed extremely dry and then screed into place as a leveling mortar bed. The mortar bed is compatible with cement based and most water based latex adhesives. Standard mix designs are 4:1 and 3:1. Special mix designs available.

 Dry Pack Data Sheet 236 Kb

 Dry Pack MSDS 68 Kb